March 28, 2024, 06:58:19 pm

News:

Unlogical names will be denied acces. Check your mail/spambox!


Test kits approved in DSR

Started by glennf, March 07, 2014, 11:52:17 pm

Previous topic - Next topic

glennf

March 07, 2014, 11:52:17 pm Last Edit: January 18, 2015, 08:09:12 pm by glennf
ENG

Which tests to be used for DSR?
When developing DSR i used the following tests :

Salinity: Refracto meter, Calibrated at 35ppt with salifert Refracto check
KH: Salifert KH
Calcium: Salifert Ca
Magnesium: Salifert Mg
Potassium: RedSea Reef Care Potassium test
make sure titrant D is above 25 Celcius when using the potassium test. Otherwise there will be precipitation on the bottom of the bottle which look like crystals. This wil make the test and future test result useless.
if you put the bottle for 10 minutes (before each test) into a pocket close to your body it wil heat up and the crystals will go back into solution.
Strontium: Salifert Sr
Boron: Salifert Borium
Iodine: Salifert I2
Phosphate* (PO4): RedSea Reef care PO4 test 
Nitrate: Salifert NO3*
Iron*:  Sera Fe test (it works fine, I calibrated it with my own Fe solution on fresh and saltwater)
Redsea Fe test works fine, but it is a little slow, at 20-22 Celsius i takes one hour to get the right result.


* marked are strongly recommended.



NL

Welke testen te gebruiken in DSR?
Bij de ontwikkleing van DSR heb ik de volgende testen gebruikt :

Saliniteit: Refracto meter, gecalibreerd op  35ppt met salifert Refracto check
KH: Salifert KH
Calcium: Salifert Ca
Magnesium: Salifert Mg
Kalium: RedSea Reef Care Potassium tester
zorg ervoor dat titrant D van de potassium test boven de 25graden celcius is. Als dat niet het geval is vorm zich kristallen op de bodem van de fles, wat de test totaal onbetrouwbaar maak, maar ook toekomstige test resultaten worden erdoor beinvloed, omdat de concentratie niet meer klopt.
Als je de fles 10 minuten in je broekzak stopt voor het testen, is dat genoeg om alle kristallen weer in oplossing te laten gaan.
Strontium: Salifert Sr
Boor: Salifert Borium
Jodide: Salifert I2
Fosfaat* (PO4): RedSea Reef care PO4 test 
Nitraat: Salifert NO3*
Ijzer*:  Sera Fe test (werk prima op zoet en zout, door my gecalibreerd op een referentie oplossing)Redsea Fe test is bruikbaar, maar is traag bij 20-22 Celsius. Het duurt het meer dan een uur om het gewenst resultaat te produceren.

* gemarkeerd raad ik ten sterkste aan.

glennf

February 18, 2015, 09:01:45 am #1 Last Edit: December 07, 2016, 05:40:03 pm by glennf
UPDATE:

Please pay special attention to the Red marked tests, because the results may depend on those test.
- never use salifert PO4 test for PO4 dosing because the low rage measurements are not good enough and will cause overdosing.
- never use  Redsea NO3 test to  dose NO3, because the test result are not good enough and will cause overdosing.
- any other test brand not mentioned have not been tested, so the accuracy has not been determined.


glennf

January 16, 2017, 07:47:00 pm #2 Last Edit: January 16, 2017, 07:49:54 pm by glennf
Update:

ENG

Which tests to be used for DSR?
When developing DSR i used the following tests :

Salinity: Refracto meter, Calibrated at 35ppt with salifert Refracto check
KH: Salifert KH
Calcium: Salifert Ca
Magnesium: Salifert Mg
Potassium: RedSea Reef Care Potassium test / Salifert Potassium* (production 2016)
make sure titrant D is above 25 Celcius when using the potassium test. Otherwise there will be precipitation on the bottom of the bottle which look like crystals. This wil make the test and future test result useless.
if you put the bottle for 10 minutes (before each test) into a pocket close to your body it wil heat up and the crystals will go back into solution.
Strontium: Salifert Sr
Boron: Salifert Borium
Iodine: Salifert I2
Phosphate* (PO4): RedSea Reef care PO4 test
Nitrate: Salifert NO3* (with NO3 1605 color card)
Iron*:  Sera Fe test (it works fine, I calibrated it with my own Fe solution on fresh and saltwater)
Redsea Fe test works fine, but it is a little slow, at 20-22 Celsius i takes one hour to get the right result.

* marked are strongly recommended.
* marked = value for your money.

=============================================================

NL

Welke testen te gebruiken in DSR?
Bij de ontwikkeling van DSR heb ik de volgende testen gebruikt :

Saliniteit: Refracto meter, gecalibreerd op  35ppt met salifert Refracto check
KH: Salifert KH
Calcium: Salifert Ca
Magnesium: Salifert Mg
Kalium: RedSea Reef Care Potassium tester / Salifert Potassium* (productie 2016)
zorg ervoor dat titrant D van de potassium test boven de 25graden celcius is. Als dat niet het geval is vorm zich kristallen op de bodem van de fles, wat de test totaal onbetrouwbaar maak, maar ook toekomstige test resultaten worden erdoor beinvloed, omdat de concentratie niet meer klopt.
Als je de fles 10 minuten in je broekzak stopt voor het testen, is dat genoeg om alle kristallen weer in oplossing te laten gaan.
Strontium: Salifert Sr
Boor: Salifert Borium
Jodide: Salifert I2
Fosfaat* (PO4): RedSea Reef care PO4 test
Nitraat: Salifert NO3* (met NO3 1605 kleurenkaart)
Ijzer*:  Sera Fe test (werk prima op zoet en zout, door my gekalibreerd op een referentie oplossing)Redsea Fe test is bruikbaar, maar is traag bij 20-22 Celsius. Het duurt het meer dan een uur om het gewenst resultaat te produceren.

* gemarkeerd raad ik ten sterkste aan.
* gemarkeerd = waar voor je geld.

glennf

September 08, 2022, 03:35:55 am #3 Last Edit: September 08, 2022, 03:38:20 am by glennf
The redsea PO4 (2022) test is NOT recommended anymore because it can't measure PO4 higher than 0,08ppm.

Use this updated list:
Http://dsrreefing.com/testkits/